The value is placed after the symbol element +, – or tin the area a1(see Figure A.1). The deviation from ideal nominal shape can be controlled by indication of a size. Transition line, included in an intersection plane, which is not defined on the nominal model and which exists between two adjacent integral surfaces ISO 3098-0:1997, Technical product documentation一Lettering 一Part 0: General requirements For undated references,the latest edition of the referenced document (including any amendments) applies. For dated references, only the edition cited applies. The following document, in whole or in part, is normatively referenced in this document and is indispensable for its application. In cases where the geometrically defined shape of an edge (for example 1×45°) is required, the general dimensioning principles given in ISO 129-1 apply. NOTE The undefined edge can only be specified in 2D drawings. BS ISO 13715:2014 pdf free.Technical product documentation一Edges of undefined shape-Indication and dimensioningīS ISO 13715 specifies rules for the indication and dimensioning of undefined edges in technical product documentation.The proportions and dimensions of the graphical symbols to be used are also specified.
0 Comments
Leave a Reply. |